houseboat magazine
Your Ultimate Online Houseboating Resource
Welcome to Houseboat Magazine
Contact UsAdvertise

AFTERMARKET MANUFACTURERS BROKERS FORUMS
Administered by The Pirate
Results 1 to 5 of 5

Thread: Top Deck Anchor Line Windlass

Threaded View

  1. #1
    Senior Member Endurance's Avatar
    Join Date
    Nov 2005
    Location
    Lake Powell, Utah
    Posts
    271

    Top Deck Anchor Line Windlass

    I am considering adding a way to attach an anchor line to the rear of my top deck.

    At Lake Powell, the typical way to "anchor" a houseboat is to nose it up onto shore, then use anchor lines that start at each of the rear corners of the houseboat and leave the boat at about a 45 degree angle to an anchor point on shore. We do the same thing with the two corners of the bow, but that is a separate discussion for another day.

    The issue with the rear anchor lines is that if you imagine an anchor line leaving each rear corner of the boat and heading to the shore at a 45 degree angle, you have put a line across the best spot to tie a smaller ski boat or fishing boat up to the side of the houseboat. At Lake Powell, you typically take a "play" boat for skiing, fishing, or sightseeing on every trip.

    Over the years, I have tried a lot of workarounds like tying up the little boat to the back of the houseboat instead of the sides, attaching my rear anchor line to the houseboat 20 feet or so forward of the rear corner to leave the back part of the boat side more open, or tying the "play" boat directly to the houseboat's rear anchor line using a Prussic knot.

    While my workaround methods all have their good points, what I would really like to do is attach the anchor line to the top deck so that I just dock my little boat alongside the houseboat by going under the anchor line. I am thinking of something like an aluminum post that would top out 3 feet or so above the rear portion of my top deck and extend down through the roof and my rear deck area to ultimately attach at the bottom to crossmembers at the hull.

    While I'm at it, I am considering using something that sailors would call a sheet winch on top of the aluminum post to allow me to better tighten the anchor lines.

    Does anyone have any experience with anything like this?
    Last edited by Endurance; 03-26-2018 at 10:36 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts