Forum: Maintenance

Hello, I did a search on AC circuit breakers here on the forum and also looked on the www but couldn't find what I was looking for, so here's my...

I recently finished my new floor boards which is actually the cabin sole directly over 2 Crusader 270 engines. There are 8 boards are approx. 2' X 3'...

After running the boat for awhile, should my V-drives be hot to the touch? As in so hot it will burn your hand? Both drives seem to get really hot...

Starting to look into replacing the batty charger in the engine compartment. We have a house bank, a starting battery, both on a switch. also a gen...

Last March or so I bought 8 new 6V AGM batteries for my inverter system. The guy who sold me the batteries also installed them with custom wiring...

As I continue on the remodel of my 82 Gibson lazy Cruz (first houseboat) have another decision to make . Being i am going to replace my current house...

I found some very good discussions on inverter batteries in the old forum. The posts are all several years old and I'm guessing things have changed...

I've searched here on the forum and Googled this subject but with no luck. Has anyone made an Excel spread sheet covering a comprehensive...

I didn't want to hijack the thread that just started on batteries ( I am really excited to see the posts on that subject) so I will start this one on...

Pulling my boat out of the water in the next couple of days. I have always had a small leak somewhere in the starboard transom assembly. I blew...

I have a 7.5kw Kohler genset on my houseboat. Do I just drain it out where the stickers on it tell me and then run some antifreeze through the...

One of my engines overheated a few weeks ago after the raw water intake got clogged. Afterwards I noticed lots of engine oil in the bilge and the...

Which would you use on interior woodwork and why?

What are the brands of additives everyone buys to stabilize their fuel? I know there's Sta-bil, but this stuff is expensive. Sta-bil will run me...

I'm afraid I might have to replace our fresh water pump next weekend. I say "might" because I didn't have my volt meter with me to confirm power is...

As the owner of a Gibson (used) and a potential purchaser of a new boat from Gibson in the next couple of months I need to express some extreme...

Hello All, I am getting ready to winterize my 1996 Lakeview with twin 350's and a Westerbeke generator. Aside from the obvious, anti-freeze, oil and...

My gen's oil is 2 seasons old now. Previous owner told me it was changed shortly before I bought the boat, so I figured I'd change it after this...

Any cost efficient ideas on quieting down the exhaust on our Gibson? We've got four dry exhausts (with baffles I think) and the boat can get a...

I have the dual Sherwood pumps on my Kingscraft, and the impellers on the port engine side keep failing every ~20 hours of run time. I'm guessing...